Masterflash Roof Flashing, 1/4 X 4 In.

Description

1/4″ x 4″, Master Flash Roof Flashing, Slides Over Pipe, For Pitch To 40 Degrees, Uses Silicone Sealant Between Base & Surface, Easily Secures To Roof With Sheet Screws, Molds To Metal, Plastic, Etc, & Has A Non Fading EPDM Collar, Rated 200 Degrees Fahrenheit Continuous Heat, Iapmo/UPC Listed.

Closed to 5-3/4 in. Master Flash® EPDM roof flashing

8 in. x 8 in. soft aluminum base for profiled metal roofs

For any panel configuration, roof pitch or pipe location

Molds to all types of roofing surfaces, including metal, plastic, tile and rubber membrane

Marked cut lines allow for easy installation and customization for various pipe sizes with a sharp knife or scissors

Slide over pipe, use silicone sealant between base and surface, then secure with sheet metal screws

Non-fading EPDM collar provides maximum resistance to weathering caused by ozone and UV rays

Rated to withstand 212°F continuous heat and approved for Type B installations; intermittent temperature resistance to 275°F